Product Description
DESCRIPTION
The WL25 is designed to reject interference from CRT, DLP and LED Displays. This IR Receiver mounts easily into a single gang, electrical J-Box, is supplied with mounting screws, and comes with a Decorator-style insert, allowing the installer to use a Decorator-style wall cover plate. This provides an integrated look for control of A/V equipment behind closed doors or any IR Repeater System that is in close proximity to light sources described above.
FEATURES
• J-Box Mounting with Decorator-style insert (available in white (included), ivory, almond, & black)
2. You can confirm the source of the interference by temporarily turning off TV sets, isolating the Micro Link IR Receiver from all sunlight and turning off all lights, light dimmers and Infrared security systems. Then check to see if the Micro Link IR Receiver operates the component.
• 4-screw terminal block for interface to Xantech Connecting Blocks
• Works in normal 3-wire mode
• RF Grid included for EMI reduction
• Talk Back LED for IR reception and full system operation indication
• Sometimes interference will cause the red Talk-Back LED on the front of the Micro Link IR Receiver to blink dimly, intermittently, or continuously.
• 7 units may be powered by one 781ERGPS power supply (regulated 12VDC 200mA supply)
Note: The WL25 will not operate in 2-wire Phantom Power mode
• The Talk-Back Led should only blink when you are sending infrared commands to the Micro Link IR receiver from a remote control.
SPECIFICATIONS
• Infrared modulation frequency bandwidth: 25 – 60 kHz
• It may be necessary to move either the interfering source of the Micro Link IR Receiver to achieve proper operation.
• Reception range: up to 80 feet (18M), depending on remote control output strength and ambient conditions.
3. If the Talk-Back LED or the 286D Emitters do not blink when you are sending IR commands to the Micro Link IR Receiver from a remote control, check the following:
• Reception angle: 55 degrees off axis at 50% range reduction
• Cable requirements: 3-conductor. Use 24-gauge up to 200′ (61M), 22 gauges up to 600′ (180M), 20-gauge up to 2000′ (600M), 18-gauge up to 5000′ (1.5KM) — unshielded OK.
• Make sure the power supply is plugged securely into a live AC electrical outlet.
• Maximum transmission length: One mile using 18-gauge wire (1.6KM)
• Be sure the stereo mini plug of the Micro Link IR Receiver is plugged into the “IR RCVR” jack on the CB12 Connecting Block, not into the “OUT” jack.
• Maximum current output: 100 mA (pulse)
• Dimensions: 1-3/4” W x 4-1/8” H x 1-1/8” D
• Power requirements: 12 volts DC @ 20mA