Indigo Distribution » Products

79000 – Multiple Emitter Connecting Block

Matthew — Fri, 13 Feb 2015 15:50:52 +0000

Emitter expansion block for the 791-44 or 792-10
Parallel emitter ports drive 10 single or 10 dual emitters
Contains a series 100-Ohm resistor per emitter port
Emitter and IN/OUT ports are 3.5 mm mono mini-jacks
Screw terminals provide for wired input connections
Requires the 792-10 Power Module or the 791-44 Amplified Connecting Block to drive the 790 block
Dimensions: 6″ x 2 1/4″ x 15/16″ (153mm x 58mm x 24mm)

The post 79000 – Multiple Emitter Connecting Block appeared first on Indigo Distribution.

79144 – One Zone Ten Source Amplified Connecting Block

Matthew — Fri, 13 Feb 2015 16:03:12 +0000

Emitter port jumpers permit high or low power IR outpout
High-speed opto-isolator for improved operation
Parallel emitter ports drive 10 single or 10 dual emitters
Contains red LED input signal Test-IR
Requires either the 781ERGPS or 782ERGPS Power Supply
Dimensions: 6″ x 2 1/4″ x 15/16″ (153mm x 58mm x 24mm)
Up to nine 790-00’s can be connected to the 791-44 for control of up to 100 devices in a single zone
STATUS terminal for connection of Xantech IR Receivers and Keypads that have status indicator LED’s
Quick connect stereo mini jack for Xantech IR Receivers that use a stereo mini plug

The post 79144 – One Zone Ten Source Amplified Connecting Block appeared first on Indigo Distribution.

XLIP232 – IP-RS232 Connecting Block

Matthew — Mon, 16 Feb 2015 13:05:21 +0000

XLIP200 modules will typically be setup as a source (receiver) and a destination (emitter) in a two (or more) module system with at least one module setup as a receiver and at least one module setup as an emitter to receiver, transmit and output IR.

In receiver mode, with an external IR receiver connected, the XLIP200 will receive an IR command, convert it to packet data and send that data to a pre-determined IP address, typically another XLIP200 in emitter mode.

n emitter mode, the XLIP200 will decode the received data and output IR, as originally received, via a connected IR emitter.

Depending on configuration, one XLIP200 in receiver can send data to multiple XLIP200s in emitter mode, or multiple XLIP200s in receiver mode can send data to a single XLIP200 in emitter mode.

XLIP232 inludes the same features as XLIP200 with RS232 Commands.

XLIP232 Modules will typically be setup as a source (server) and a destination (client) in a two or more module system. Depending on configuration, one XLIP232 in receiver/ server can send data to multiple XLIP232’s in emitter/client mode, or multiple XLIP232’s in receiver/server mode can send data to a single XLIP232 in emitter/client mode

The post XLIP232 – IP-RS232 Connecting Block appeared first on Indigo Distribution.